Adding An Override Server - Fortinet FortiGate FortiGate-100A Install Manual

Configuring the FortiGate unit
5
1
2
1
2
3
4
5
FortiGate-60 series and FortiGate-100A FortiOS 3.0 MR4 Install Guide
01-30004-0266-20070831
Daily Once a day. You can specify the time of day to check for updates.
Weekly Once a week. You can specify the day of the week and time of day
to check for updates.
Select Apply.
The FortiGate unit starts the next scheduled update according to the new update
schedule.
Whenever the FortiGate unit runs a scheduled update, the event is recorded in
the FortiGate event log.
To enable schedule updates from the CLI
Log into the CLI.
Enter the following command:
config system autoupdate schedule
set day
set frequency
set status
set time
end
Example
config system autoupdate schedule
set update every Sunday
set frequency weekly
set status enable
set time 16:45
end

Adding an override server

If you cannot connect to the FDN, or if your organization provides updates using
their own FortiGuard server, use the following procedures to add the IP address of
an override FortiGuard server in either the web-based manager or the CLI.
To add an override server from the web-based manager
Go to System > Maintenance > FortiGuard Center.
Select the blue arrow for AntiVirus and IPS Downloads to expand the options.
Select the Use override server address check box.
Type the fully qualified domain name or IP address of a FortiGuard server.
Select Apply.
The FortiGate unit tests the connection to the override server.
If the FDN setting changes to available, the FortiGate unit has successfully
connected to the override server.
If the FDN stays set to not available, the FortiGate unit cannot connect to the
override server. Check the FortiGate configuration and network configuration for
settings that would prevent the FortiGate unit from connecting to the override
FortiGuard server.
Next Steps
47