Configuring Modem Settings - Fortinet FortiGate FortiGate-100A Install Manual

Configuring the modem interface
1
2
3
4
1
2
3

Configuring modem settings

FortiGate-60 series and FortiGate-100A FortiOS 3.0 MR4 Install Guide
01-30004-0266-20070831
To operate in stand alone mode for the FortiGate-60M
Go to System > Network > Modem.
Configure other modem settings as required.
See "Configuring modem settings" on page
Make sure there is correct information in one or more Dial-up Accounts.
Configure firewall policies for connections to the modem interface.
See "Adding firewall policies for modem connections" on page
Select Dial Up.
The FortiGate unit initiates dialing into each dial-up account in turn until the
modem connects to an ISP.
To operate in stand alone mode on the CLI
Log into the CLI.
Enter the following to configure a stand alone modem:
config system modem
set status enable
set status mode standalone
end
Enter the following to configure the dialup account:
config system modem
set auto-dial
set idle-timeout <minutes_interger>
set passwd1 <passwrd_srt>
set phone1 <phone-number_str>
set redial <tries_interger>
set username1 <name_str>
end
Configure modem settings so that the FortiGate unit uses the modem to connect
to your ISP dial-up accounts. You can configure the modem to connect up to three
dialup accounts. You can also enable and disable FortiGate modem support,
configure what the modem dials, and select the FortiGate interface that the
modem is redundant for.
Configuring modem settings
51.
57.
51