Factory Default Dhcp Server Configuration; Factory Default Nat/Route Mode Network Configuration - Fortinet FortiGate FortiGate-100A Install Manual

Factory default DHCP server configuration

Factory default DHCP server configuration

Factory default NAT/Route mode network configuration

24
Using the factory default DHCP server settings, you can quickly configure the
internal network and the FortiGate unit. See
defaults" on page 21.
Table 2: Factory default DHCP server configuration
Name internal_dhcp_server
Interface Internal
Default Gateway 192.168.1.99
IP Range 192.168.1.110 – 192.168.1.210
Network Mask 255.255.255.0
Lease Duration 7 days
DNS Server 1 192.168.1.99
When the FortiGate unit is first powered on, it is running in NAT/Route mode and
has the basic network configuration listed in
configuration allows you to connect to the FortiGate unit web-based manager and
establish the configuration required to connect the FortiGate unit to the network. In
Table 3 on page 24, HTTPS administrative access means you can connect to the
web-based manager using HTTPS protocol through this interface. Ping
administrative access means this interface responds to ping requests.
Table 3: Factory default NAT/Route mode network configuration
Administrator account
Internal interface
WAN1 interface
WAN2 interface
No default on the 60Bs.
DMZ interface
DMZ1
(FortiGate-100A)
No default on thet 60Bs.
DMZ2 interface
(FortiGate-100A)
FortiGate-60 series and FortiGate-100A FortiOS 3.0 MR4 Install Guide
"Quick installation using factory
Table 3 on page
User name:
Password:
IP:
Netmask:
Administrative Access:
IP:
Netmask:
Administrative Access:
IP:
Netmask:
Administrative Access:
IP:
Netmask:
Administrative Access:
IP:
Netmask:
Administrative Access:
Factory defaults
24. This
admin
(none)
192.168.1.99
255.255.255.0
HTTP, HTTPS,
Ping
192.168.100.99
255.255.255.0
Ping
192.168.101.99
255.255.255.0
Ping
10.10.10.1
255.255.255.0
HTTPS, Ping
0.0.0.0
0.0.0.0
Ping
01-30004-0266-20070831