Epson ET-4750 User Manual page 34

User's Guide
Related Information
"E-1" on page 34
&
"E-2, E-3, E-7" on page 34
&
"E-5" on page 35
&
"E-6" on page 35
&
"E-8" on page 36
&
"E-9" on page 36
&
"E-10" on page 37
&
"E-11" on page 37
&
"E-12" on page 38
&
"E-13" on page 38
&
"Message on the Network Environment" on page 39
&
E-1
Message:
Confirm that the network cable is connected and network devices such as hub, router, or access point are turned
on.
Solutions:
❏ Make sure the Ethernet cable is securely connected to your printer and to your hub or other network device.
❏ Make sure your hub or other network device is turned on.
E-2, E-3, E-7
Message:
No wireless network names (SSID) found. Confirm that the router/access point is turned on and the wireless
network (SSID) is set up correctly. Contact your network administrator for assistance.
No wireless network names (SSID) found. Confirm that the wireless network name (SSID) of the PC you wish to
connect is set up correctly. Contact your network administrator for assistance.
Entered security key/password does not match the one set for your router/access point. Confirm security key/
password. Contact your network administrator for assistance.
Solutions:
❏ Make sure your access point is turned on.
❏ Confirm that your computer or device is connected correctly to the access point.
❏ Turn off the access point. Wait for about 10 seconds, and then turn it on.
❏ Place the printer closer to your access point and remove any obstacles between them.
❏ If you have entered the SSID manually, check if it is correct. Check the SSID from the Network Status part on
the network connection report.
❏ If you are using push button setup to establish a network connection, make sure your access point supports
WPS. You cannot use push button setup if your access point does not support WPS.
Network Settings
34