Epson ET-4550 Start Here

ET-4550
Start Here
Read these instructions before using your product.
Note for Spanish speakers/Nota para hispanohablantes:
obtener instrucciones de configuración en español, consulte la Guía de
instalación en epson.com/support/et4550sp (requiere una conexión a
Internet).
1
Unpack
Note:
• Your product includes 4 Initial bottles that are designed for product
setup and 4 additional bottles (1 black bottle and 3 smaller color
Bonus bottles) for refilling.
• Do not open the ink bottles until you are ready to fill the ink tanks.
The ink bottles are vacuum packed to maintain reliability.
1
Remove all protective materials from the product.
2
Lift up the scanner unit and remove all protective materials
from inside the product.
Caution: Do not touch the translucent part or ink tubes.
3
Para
2
Note:
gloves and place a sheet of paper under the ink tank when you
fill or refill the ink tanks, as ink may splatter. If ink spills, wipe it off
immediately with a damp towel to avoid permanent stains. If ink gets on
your clothes or belongings, it may not come off.
Warning:
French control
drink the ink.
panel sticker
1
Transportation
kit
2
3
4
Lower the scanner unit.
Fill ink tanks
This product requires careful handling of ink. Wear disposable
Keep the ink bottles out of the reach of children and do not
Open the ink tank unit cover, then remove the cap for the
black ink tank and attach it to its holder.
Unpack the black Initial ink bottle.
Snap the bottle tip off, then remove the bottle cap.
Carefully remove the protective seal (avoid touching the ink
underneath the seal), then close the bottle cap tightly.
Caution: Be sure to close the bottle cap tightly, or ink may leak.
Fill the tank using all of the ink in the bottle.
Note: Refer to the color coded sticker above the ink tank unit to
identify the color of each tank.
Caution: Be sure to fill each tank with the correct ink color.