Making Wi-Fi Settings By Push Button Setup (Wps) - Epson ET-4750 User Manual

User's Guide
6. Enter the password.
Note:
❏ The password is case-sensitive.
❏ If you do not know the password, check if it is written on the label of the access point. If you are using the access point
with its default settings, use the password written on the label. The password may also be called a "Key", a
"Passphrase", and so on.
❏ If you do not know the password for the access point, see the documentation provided with the access point, or
contact the person who set it up.
7. When you have setup finished, tap Start Setup.
8. Tap OK to finish.
Note:
If you fail to connect, load A4 size plain paper, and then select Print Check Report to print a connection report.
9. Close the network connection settings screen.
Related Information
"Entering Characters" on page 21
&
"Checking the Network Connection Status" on page 31
&
"When You Cannot Make Network Settings" on page 182
&

Making Wi-Fi Settings by Push Button Setup (WPS)

You can automatically set up a Wi-Fi network by pressing a button on the access point. If the following conditions
are met, you can set up by using this method.
❏ The access point is compatible with WPS (Wi-Fi Protected Setup).
❏ The current Wi-Fi connection was established by pressing a button on the access point.
Note:
If you cannot find the button or you are setting up using the software, see the documentation provided with the access point.
1. Tap on the home screen.
2. Select Wi-Fi (Recommended).
If the printer has already been connected by Ethernet, select Router.
3. Tap Start Setup.
If the network connection is already set up, the connection details are displayed. Tap Change Settings to
change the settings.
If the printer has already been connected by Ethernet, tap Change to Wi-Fi connection., and then select Yes
after checking the message.
4. Select Push Button Setup (WPS).
Network Settings
27