Removing The Seat Assembly; Installing The Seat Assembly; Lubrication; Greasing The Machine - Toro Workman GTX Operator's Manual

Removing the Seat
Assembly
1. Push the seat assembly forward to the raised
position (Figure 25).
2. Slide the seat assembly to the side out of the
pins, and lift the seat assembly upward
26).
Figure 26
1. Pins
Installing the Seat
Assembly
Slide the seat assembly onto the pins and lower the
seat assembly (Figure
Figure 27
1. Pins
(Figure
27).

Lubrication

Greasing the Machine

Service Interval: Every 100 hours/Yearly (whichever
Grease Type: No. 2 lithium grease
1. Use a rag to wipe the grease fitting clean so that
foreign matter cannot be forced into the bearing
or bushing.
2. With a grease gun, apply 1 or 2 pumps of grease
into the grease fittings on the machine.
3. Wipe the excess grease off the machine.
The grease fittings are located at the inner end of the
control arms, the tie-rod ball joint, and the outer end
of the control arms
g190187
g190186
31
comes first)—Grease the bearings
and bushings. Grease the machine
more frequently when using it for
heavy-duty operations.
(Figure 28 and Figure
Figure 28
Figure 29
29).
g034057
g034058