Sony ZRD-1 Operating Instructions Manual page 13

setting values for [Contrast] to [Color
Temperature Settings]. If necessary, change the
values for [Contrast] to [Color Temperature
Settings]. The setting values are identical for
each mode under factory default settings.
[Contrast]: Use the slider and
the contrast.
Setting range: 0 to 100
Default value: 60
[Brightness]: Use the slider and
adjust the brightness.
Setting range: 0 to 100
Default value: 50
[Gamma]: Select the gamma correction value.
Default value: 2.2
Caution
• This product is not a medical device. The
device cannot be used for medical
examinations, even when [DICOM SIM] is
selected.
• The [Gamma] settings will be disabled if
[HDR] is set to a setting other than [Off].
[HDR] (version 1.20.0 or later only): Select the
playback mode for HDR (high dynamic range)
content.
• [SMPTE ST 2084]
• [S-Log3]
• [Off]
[Color Space]: Select the color space.
• [Native]: Display the picture using the original
color space that is input.
• [sRGB]: Display the picture using the sRGB
color space standard.
• [AdobeRGB]: Display the picture using the
Adobe RGB color space standard.
• [DCI] (before version 1.20.0 only): Display the
picture using the DCI color space standard.
• [DCI_P3] (version 1.20.0 or later only):
Display the picture using the DCI color space
standard.
• [BT.2020]: Display the picture using the
BT.2020 color space standard.
• [Custom6] to [Custom10] (version 1.20.0 or
later only): Display pictures using a custom
color space.
Caution
[AdobeRGB], [DCI], and [BT.2020] do not
include the entirety of the color spaces defined by
their respective standards.
[Light Output] (version 1.20.0 or later only):
Select the output strength to use during low light-
buttons to adjust
buttons to
3
4
13
source output. For details, refer to the Installation
Manual.
• [Full]: Output at 100% strength.
• [High]: Output at 75% strength.
• [Medium]: Output at 50% strength.
• [Low]: Output at 25% strength.
Caution
The [Light Output] setting will be disabled if
[HDR] is set to a setting other than [Off].
[Color Temperature Settings]: Select the color
temperature in [Color Temperature].
• If you selected [D93], [D65], or [D50], proceed
to step 4 .
• If you selected [D93 Custom (Offset)], [D65
Custom (Offset)], or [D50 Custom (Offset)],
proceed to step 3 .
Configure the offset values.
These settings can only be configured when [Color
Temperature Settings] is set to "Custom (Offset)" in
step 2 .
Use the slider and buttons to adjust the contrast.
Setting range: –128 to +127
Default value: 0
When you are finished configuring settings, click
[Close].