Changing The Display Starting Positions Of Pictures; Configuring The Input Level And Signal Format For Hdmi Inputs (Zrct-200 Only) - Sony ZRD-1 Operating Instructions Manual

Changing the Display Starting
Positions of Pictures
You can change the display positions for each picture.
For example, you can move a low-resolution picture from
the top left of the screen to the center.
1
Click [Detailed Input Settings] in the [Input Settings]
screen.
The [Detailed Input Settings] screen appears.
Before version 1.20.0
Version 1.20.0 or later
2
Click the tab ([DVI], [DisplayPort (Single1)],
[DisplayPort (Single2)], [DisplayPort (Dual)],
[HDMI1], or [HDMI2]) of the video signal for which
you want to change the display starting position.
Caution
The [DVI] tab is only available for the ZRCT-100, and
the [HDMI1] and [HDMI2] tabs are only available for
the ZRCT-200.
3
Use the sliders and
[V Position] to specify the horizontal and vertical
positions.
The settings are reflected in the picture immediately
after they are configured.
For details, refer to the Installation Manual.
buttons for [H Position] and
4
Click [Close].
The [Detailed Input Settings] screen closes.
Configuring the Input Level and
Signal Format for HDMI Inputs
(ZRCT-200 Only)
1
Select [HDMI1] or [HDMI2] for [Input Select] in the
[Input Settings] screen, and click [OK] or [Apply].
The video input changes.
2
Click [Common Input Settings].
The [Common Input Settings] screen appears. The
settings configured on the primary controller will be
applied to all the other display controllers, including
the sub controllers. Sub controllers cannot be
configured individually.
3
Configure each setting.
[Dynamic Range]: Select the video input level for
HDMI connectors 1 and 2.
• [Auto]: Determine the video input level
automatically.
• [Limited]: Select this when the video input
level is between 16 to 235.
• [Full]: Select this when the video input level is
between 0 to 255.
[HDMI Signal Format]: Select the video signal
format.
• [Enhanced Format]: Display pictures in a
higher definition HDMI format.
• [Standard Format]: Display pictures in
standard HDMI format.
Caution
Select [Standard Format] when an input device
that does not support HDMI 2.0 is connected.
4
When you are finished configuring settings, click
[Close].
11