Table of Contents
Advertisement
English
Satellite
LNB Type
LNB Power:
22KHz
DISEqC1.0/1.1
Highlight Satellite and press ENTER to access the satellite list and select one. Highlight LNB Type and
press ENTER to select the LNB type. Make sure the 22KHz, DISEqC1.0/1.1 switch is corresponding to the
selected satellite. After the above steps are finished, press the BLUE button to search for channels.
5.4.3 DTV Manual Tuning (in DVB-T/C mode only)
Search and store programmes manually.
Select the source type DVB-T or DVB-C and search digital programmes manually. In the Channel menu,
select DTV Manual Tuning and press ENTER to access. Press t u to select a Channel No., and then press
ENTER to start the search. The search stops when a programme is found and this programme will be
stored in the current channel position. If you want to stop the search, press MENU.
5.4.4 ATV Manual Tuning (in DVB-T/C mode only)
First select the source type of ATV. Then in the Channel menu, select ATV Manual Tuning and press
ENTER to access. Highlight and press p q to select Storage To 1 (maybe other number), Sound System
and Channel No.. Then select search and press ENTER to start the search. Press u for the unit to search
towards higher frequency. Press t for the unit to search towards lower frequency. The search stops
when a programme is found and this programme will be stored in the current channel position. If you
want to stop the search, press MENU.
Fine-Tune
Use this option to make small adjustments to tuning of an individual channel. Fine-tune is not
necessary under normal conditions. However, in area of inferior broadcast conditions where adjustments
is necessary for a better picture and sound, use fine-tune. Select a channel that you want to fine tune. In
the Channel menu, select ATV Manual Tuning and press q to highlight Fine-Tune. Press t u to fine tune
until the best possible picture and sound are obtained.
5.4.5 Channel settings
Programme Edit
Signal Information
Cl information
5 V Antenna Power
Software Update (OAD)
OAD Tuning
*Only for some regions.
Select the satellite for this TV.
Make sure the LNB type is corresponding to your dish.
Set the power supply for the LNB (usually 13/18 V).
Select the 22KHz to set 22K switch to ON/OFF. The Auto mode (recommended) is
used to switch 22KHz on or off depending on the LNB type.
Select the DiSEqC mode for the selected LNB.
Edit the programmes. You can press the COLOUR BUTTONS on the remote
control to skip programmes, rename and delete programmes or move
programmes, and add programmes to the favourite list by pressing FAV.
Showing the information of current DTV channel.
Enables the user to select from the CAM-provided menu. Select the Cl menu
based on the menu PC card.
This option is only available in DVB-T source, select On to supply power for
the TV's antenna. Select Off to turn off this function.
Select On to allow the TV to update the system software over the air. Select
Off will turn off this function.*
When software update (OAD) is off, this option is disabled. By selecting OAD
scan you can scan channels to find the OAD update information.*
13
Advertisement
Table of Contents
