Replacing The Fuses; Servicing The Battery - Toro multi-pro 1200 Operator's Manual

Installing the Spark Plug
1. Install the spark plugs and metal washers.
2. Tighten the spark plugs to 18 to 22 ft-lb (24.4 to
29.8 N m).
3. Push the wires onto the spark plugs (Fig. 49).
4. Close and latch the seat.

Replacing the Fuses

There are 2 fuses and 2 empty slots in the electrical system.
They are located beneath the seat (Fig. 51).
Main electrical system
Spray system
Open
Open
1
2
3
4
Figure 51
1. Main electrical system
2. Spray system
s
30 amp
10 amp
20 amp
30 amp
3. Open 20 amp
4. Open 30 amp
36

Servicing the Battery

Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Important
Do not jump start the sprayer.
Always keep the battery clean and fully charged. Use a
paper towel to clean the battery and battery box. If the
battery terminals are corroded, clean them with a solution
of four parts water and one part baking soda. Apply a light
coating of grease to the battery terminals to prevent
corrosion.
Voltage: 12 volt with 280 cold cranking Amps @ 0 F
Removing the Battery
1. Position the sprayer on a level surface, set the parking
brake, stop the pump, stop the engine, and remove the
ignition key.
2. Loosen the knobs on the sides of the battery box and
remove the battery cover (Fig. 52).
1
Figure 52
1. Knobs
3. Remove the battery retainer and fasteners (Fig. 52).
1
2
2. Battery