Replacing The Fuses (Models 22973 And 22974) - Toro TRX-16 Original Instructions Manual

1. Remove the battery from the machine; refer to
Removing the Battery (page
Important: Never fill the battery with distilled
water while the battery is installed in the machine.
Electrolyte could be spilled on other parts and
cause corrosion.
2. Clean the top of the battery with a paper towel.
3. Remove the vent caps from the battery
4. Slowly pour distilled water into each battery cell until
the electrolyte level is up to the upper line
on the battery case.
Important: Do not overfill the battery because
electrolyte (sulfuric acid) can cause severe
corrosion and damage to the chassis.
5. Wait 5 to 10 minutes after filling the battery cells. Add
distilled water, if necessary, until the electrolyte level is
up to the upper line
6. Install the battery vent caps.
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important: Always keep the battery fully charged
(1.265 specific gravity). This is especially important to
prevent battery damage when the temperature is below
0° C (32° F).
1. Remove the battery from the chassis; refer to
the Battery (page 30).
2. Check the electrolyte level; refer to
Battery Electrolyte Level (page
3. Make sure the filler caps are installed in the battery.
4. Connect a 3 to 4 amp battery charger to the battery
posts and charge the battery at a rate of 3 to 4 amperes
for 4 to 8 hours (12 volts). Do not overcharge the
battery.
5. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
6. Install the battery onto the machine and connect the
battery cables, refer to
Note: Do not run the machine with the battery
disconnected, electrical damage may occur.
30).
(Figure
(Figure
(Figure 43) on the battery case.
Removing
Checking the
31).
(Figure 44).
Installing the Battery (page
43).
43)
1. Positive Battery Post
2. Negative Battery Post
Replacing the Fuses (Models
22973 and 22974)
There are 4 fuses in the electrical system. They are under the
control panel on the left side
Start Circuit
Charge Circuit
Cooler fan Circuit
Headlight (optional)
1. Fuse block
31).
32
Figure 44
3. Red (+) Charger Lead
4. Black (-) Charger Lead
(Figure 45).
30 amp
25 amp
15 amp
15 amp
Figure 45