Using The Fingerprint Sensor - Toshiba PORTEGE Z30-C User Manual

Using the Fingerprint Sensor

Some models are equipped with the fingerprint sensor for the purpose of
enrolling and recognizing fingerprints. Align the first joint of the finger to the
center of the sensor. Lightly touch the sensor and swipe finger levelly
towards you until the sensor surface becomes visible. In performing this
process, you should also take care to ensure that the center of your
fingerprint is on the sensor.
By enrolling the ID and password onto the fingerprint authentication
feature, it is no longer necessary to input the password from the keyboard.
Fingerprint feature enables you to:
1. Fingerprint sensor
Points to note about the Fingerprint Sensor
Be aware of the following considerations when using the fingerprint sensor.
A failure to follow these guidelines might result in damage to the sensor,
sensor failure, fingerprint recognition problems or a lower fingerprint
recognition success rate.
User's Manual
The peg is square, so be careful to align the cap's square hole with
the peg.
You can buy replacement AccuPoint caps from your TOSHIBA
authorized dealer.
Sign-in to Windows
Unlock the password-protected screen-saver.
Authentication of the User Password (and, if applicable, the HDD/SSD
Password) when booting up the computer (Pre-Boot authentication).
Single Sign-On feature
Figure 4-3 Using the Fingerprint Sensor
Fingerprint cannot be used in models that do not have a fingerprint
function.
Total fingerprints which can be registered are 20 pcs.
1
1
4-7