Table of Contents
Advertisement
AXIS Q1635-E Fixed Network Camera
Hardware Overview
Color
Red
Amber
Green
Buzzer Signal for Focus Assistant
Buzzer
Fast interval
Medium interval
Slow interval
Status LED Behavior and Buzzer Signal for Levelling Assistant
For information on the Function button used for levelling the camera, see Connectors and Bittons.
Press and hold the function button (2) for more than two seconds to level the camera.
•
When the camera is level, both LEDs are steady green, and the beep is continuous.
•
When the camera is not level, the LEDs flash a combination of red, green and orange, and the beep occurs at slow intervals.
Both LEDs briefly flash green to indicate that the levelling is getting better.
Replace the Lens
Note
There is no need to restart the product after changing the lens. However, the product must be restarted if you are
interchanging between a P-Iris, DC iris or fixed/manual iris lens. In order to set the focus and position the lens, the product
must be connected to the network.
It is possible to use optional lenses for the Axis product.
To replace the lens:
1. Disconnect the iris cable.
2. Unscrew the standard lens.
3. Attach and screw on the new lens.
Note
If you select a DC iris configuration file for a P-Iris lens, an error message will appear below the iris configuration type in the
Camera Settinos page. For custom DC iris lenses, select Generic DC iris option.
To change the iris configuration:
1. Go to Setup > Video and Audio > Camera Settinos. Iris confiouration shows the current configured iris type.
2. Click Edit.
3. Select the installed iris lens from the drop-down list and click OK.
Indication
The image is out of focus.
Adjust the lens.
The image is close to focus.
The lens needs fine tuning.
The image is in focus.
Lens
Optimally adjusted
Less optimally adjusted
Poorly adjusted
10
Advertisement
Table of Contents
