Access The Product; Status Led Behavior And Buzzer Signal For Levelling Assistant; Adjust Focus - Axis Q1635-E Installation Manual

Access the Product

AXIS IP Utility and AXIS Camera Management are recommended methods for finding Axis products
on the network and assigning them IP addresses in Windows®. Both applications are free and can
be downloaded from www.axis.com/techsup
The product can be used with most operating systems and browsers. The recommended browsers are
• Internet Explorer
®
• Safari with OS X
TM
• Chrome or Firefox
For more information about using the product, see the User Manual available at www.axis.com

Status LED Behavior and Buzzer Signal for Levelling Assistant

For information on the Function button used for levelling the camera, see Connectors and Buttons.
Press and hold the function button (2) for more than two seconds to level the camera.
• When the camera is level, both LEDs are steady green, and the beep is continuous.
• When the camera is not level, the LEDs flash a combination of red, green and orange, and
the beep occurs at slow intervals.
Both LEDs briefly flash green to indicate that the levelling is getting better.

Adjust Focus

To adjust the zoom and focus follow these instructions:
Note
• Set focus as precisely as possible with the focus ring or Focus Assistant before starting
automatic fine tuning. Using the focus ring normally gives the best result.
• The iris should always be opened to its maximum while focusing. This gives the smallest
depth of field and thus the best conditions for correct focusing.
1. Open the product's home page and go to Setup > Basic Setup > Focus.
2. Under the Basic tab, click Open iris. If the button is inactive the iris is already open.
3. If focus has been set before, click Reset to reset the back focus.
4. Loosen the zoom puller and the lock screw for the focus ring (see Hardware Overview on
page 10) on the lens by turning them counter-clockwise. Move the zoom puller and the
focus ring to set zoom and focus and check the quality of the image in the image window.
If the camera is mounted so that one cannot look at the image and move the pullers at
the same time, use the Focus Assistant instead.
AXIS Q1635-E Network Camera
® ®
with Windows
®
®
with other operating systems.
23