Star SM-L200 Series Hardware Manual page 16

Charging the Battery Pack
The battery pack can be charged at ambient temperatures between 0 and 40°C.

The time required to charge the battery pack varies depending on the voltage and the ambient

temperature. Normally, it takes 4 to 5 hours to charge the battery pack.
It will take longer to charge the battery pack if you print while charging the battery pack.

Do not remove the battery pack while it is being charged.

Fully charge the battery prior to using the printer. Otherwise, the performance of the battery may be

affected.
There is no need to completely discharge or use up a rechargeable Lithium-ion battery before recharge it.

It is normal for the battery pack to be hot after it has finished charging or been used.

Do not recharge a battery pack that has just been fully charged.

Battery Pack Life
The battery can be charged approximately 300 times in the normal temperature range without losing

performance. If an extreme decline in the running time of the battery is noticed, the battery is reaching
the end of its usable life. It is recommended to replace the old battery with a new one.
Notes about Using the Battery Pack
Only use a designated battery pack.

Only use the designated battery charging method.

You cannot use a USB cable other than the designated USB cable.
Do not throw the battery into a fire, place it near a flame or heating device, or leave it in a hot environment

(under direct sunlight, in a car, etc.).
Do not use a battery pack that has been dropped or subjected to a shock in some other way.

Do not disassemble or modify the battery pack.

Do not short the terminals of the battery pack or get it wet.

Do not place the battery pack in a bag with a small metal object (such as a key).

If any battery fluid gets on your skin or clothing, immediately wash the affected area with fresh water.

Otherwise, skin damage may result.
7