Storage Hook Installation - Echo PAS-225 Operator's Manual

STORAGE
6. Drain fuel tank completely. Press purge bulb 6-7 times to remove
remaining fuel from carburetor then drain the tank again. Close choke,
start and run the engine until it stops due to lack of fuel.
7. Allow engine to cool then remove the spark plug and pour 7 cc (¼ oz.)
of fresh, clean, two-stroke engine oil into the cylinder through the spark
plug hole.
8. Pull the recoil starter handle 2-3 times to distribute the oil inside the
engine.
9. Observe the piston location through the spark plug hole. Pull the recoil
handle slowly until the piston reaches the top of its travel and leave it
there.
10. Install the spark plug (do not connect ignition cable).
PAS-225 SB Only:

Storage Hook Installation

1. Insert small end of hook into
locating hole on attachment
shaft.
2. Slide plastic cap onto end of
attachment shaft.
44
PAS-225/SB
X7722278004
© 11/2016 ECHO Inc.