Assembly; Power Head Shaft/Lower Shaft Assembly; Support Handle Installation - Echo PAS-225 Operator's Manual

PAS-225/SB

ASSEMBLY

Power Head Shaft/Lower Shaft Assembly

Parts Required:
1. Set Power Head/Shaft Assembly on a level surface.
2. Pull locator pin (A) out, and turn counterclockwise ¼
turn to lock-out position.
3. Remove vinyl cap from attachment drive shaft.
4. Remove cardboard spacer, if necessary.
5. Carefully fit attachment drive
shaft assembly into coupler (B)
to decal assembly line (C),
making sure that the inner lower
drive shaft engages the square
upper drive shaft socket.
Note: Lower bearing housing and
head assembly must be in
line with the engine.
6. Rotate locator pin (A) ¼ turn
clockwise to engage lower shaft
hole. Insure locator pin is fully
engaged by twisting lower drive
shaft. Locator pin should snap
flush in coupler. Full engagement
will prevent further shaft rotation.
7. Secure lower shaft assembly to
coupler by tightening clamping
knob (D).

Support Handle Installation

Note: Label shows minimum
spacing for support handle
location.
1. If necessary, position support
handle for comfortable operation
and securely tighten screws.
X7722278004
© 11/2016 ECHO Inc.
PAS Attachment
D
C
MIN
SPACING
ASSEMBLY
B
A
21