Canon imageRUNNER 2530 Service Manual Digest page 42

Bit Function
3 not used
4 not used
5 not used
6 not used
7 not used
Detailed Discussions of Bit 0
Selects a No Paper display for when; either the fax paper cassette or multitray is empty, or for
when the same size paper is all used up.
Detailed Discussions of Bit 1
Selects whether to check the side cassette when checking if the same size paper is all used
up.
● SSSW-SW18
List of Functions
Bit Function
0 detection of carrier between DCS and TCF
1 wait time for carrier between DCS and TCF
2 not used
3 not used
4 not used
5 not used
6 not used
7 not used
Detailed Discussions of Bit 0
For reception, the absence of the carrier between DCS and TCF may be detected. If the
machine returns FTT while the other party (PC-FAX in particular) is sending TCF to cause a
reception error, be sure to set the bit to '1'. If the error still occurs, set bit 1 of #1 SSSW SW18
to '1'. This function is valid only when the machine uses an R288F modem.
Detailed Discussions of Bit 1
For reception, the length of time during which the absence of the carrier is detected between
DCS and TCF may be set. This bit is valid when '1' is set to bit 0 of #1 SSSW SW18.
1 0
- -
- -
- -
- -
- -
T-4-16 T-4-16
1 0
detect do not detect
600msec 300msec
- -
- -
- -
- -
- -
- -
T-4-17 T-4-17
● SSSW-SW22
List of Functions
Bit Function
0 not used
1 not used
2 not used
3 Prohibit manual polling
4 not used
5 not used
6 not used
7 not used
Detailed Discussions of Bit 3
Selects whether to prohibit by manual polling (off hook key + start key).
● SSSW-SW25
List of Functions
Bit Function
Transmission telephone numbers displayed on reports
0
from CSI
1 not used
If void CSI has been received, handle as non-received
2
CSI.
3 Menu display of message language
4 not used
5 not used
6 not used
7 not used
Detailed Discussions of Bit 0
Selects the transmission telephone number displayed on reports after the completion of
transmission.
When "Called number" is selected, the telephone number the fax called is displayed on
reports.
When "Other fax number" is selected, the telephone number sent from the other fax (the CSI
signal data) is displayed on reports.
Detailed Discussions of Bit 2
At "1" on this Bit, ignore the void CSI if received and if the dial has been made at this point,
1 0
- -
- -
- -
Yes No
- -
- -
- -
- -
T-4-18 T-4-18
1 0
Other fax
Called number
number
- -
Yes No
Display Do not display
- -
- -
- -
- -
T-4-19 T-4-19
4-9
4