Fax Error Codes; Outline; User Error Code - Canon imageRUNNER 2530 Service Manual Digest

Ecode Detail Item
Code
E805 0002 Title
Description
Remedy
E805 0003 Title
Description
Remedy
3
3-8
Description
Failure of the Exhaust Fan (Front) (FAN4)
When lock signal is detected for 5 sec while the Exhaust Fan
(Front) (FAN4) is stopped.
* The same condition is detected after the error retry is
performed.
1.Disconnect and then connect the connector (J206) on the
DC Controller PCB (PCB4).
2.Replace the Exhaust Fan (Front) (FAN4).
3.Replace the DC Controller PCB (PCB4).
Unstable rotation of the Exhaust Fan (Front) (FAN4)
When lock signal failed to be detected for 5 sec while the
Exhaust Fan (Front) (FAN4) is driven.
* The same condition is detected after the error retry is
performed.
1.Disconnect and then connect the connector (J206) on the
DC Controller PCB (PCB4).
2.Replace the Exhaust Fan (Front) (FAN4).
3.Replace the DC Controller PCB (PCB4).

FAX Error Codes

Outline

■
● Error Code Outline
An error code is used to indicate a fault in a machine, and is indicated in the machine's LCD
or reports, showing the nature (symptoms) of the fault. Using the errorcode, the user or the
service man can readily find out how to correct the fault by simply referring to the User's
Manual or service manual. An error code may be either of the following two types:
•
User Error Codes
A fault indicated as a user error code is one that can easily be corrected by the user, as by
operating the machine. It takes the form of "# + number."
•
Service Error Codes
If a fault calls for a service man for correction, it is indicated as a service man error code in
the form of "## + number" or "SYSTEM ERROR E + number."
T-3-2 T-3-2
MEMO:
- A service error code expressed in the form of "## + number" will not appear on the
LCD, Error Tx Report, or Activity Report while the machine remainsin factory default
state. To check a service error code, shift bit 0 of service soft switch #1 SSSW SW01
to '1'.
- For the causes and countermeasures of error codes, refer to the separate G3/G4
Facsimile Error Code List.
■

User Error Code

● User Error Code
No. Tx/Rx
#0001 [Tx]
#0003 [Tx/Rx]
#0005 [Tx/Rx]
#0009 [Rx]
#0012 [Tx]
#0018 [Tx/Rx]
#0037
[Rx]
#0059 [Tx]
#0995/0099 [Tx/Rx]
Description
An original has jammed.
Time-out for copying or sending/receiving a single page has
occurred.
Time-out for initial identification (T0/T1) has occurred.
Recording paper has jammed or is absent.
Recording paper is absent at the other party.
Auto call initiation has failed.
Image memory overflow at time of reception has occurred.
The number you dial and connected number (CSI) does not match.
A memory communication reservation has been cancelled.
T-3-3 T-3-3