Wiring Requirements - Outdoor Lifestyles Twilight-II-C Installation Manual

B. Wiring Requirements
Intellifi re Ignition System Wiring
• Wire the appliance junction box to 110/120 VAC for
proper operation of the appliance.
WARNING! Risk of Shock or Explosion! DO NOT wire
IPI controlled appliance junction box to a switched circuit.
Incorrect wiring will override IPI safety lockout.
• Refer to Figure 6.4, Intellifi re Pilot Ignition (IPI) Wiring
Diagram.
• This appliance is equipped with an Intellifi re control valve
which operates on a 3 volt system.
• Plug the 3-volt AC transformer into the appliance junction
box to supply power to the unit OR install two D cell
batteries (not included) into the battery pack before use.
NOTICE: Batteries should not be placed in the battery
pack while using the transformer. Remove batteries before
using the transformer, and unplug the transformer before
installing the batteries. Battery polarity must be correct or
module damage will occur.
BLACK WIRE CAN BE
PLUGGED INTO ANY OF
#1 - #5 LOCATIONS
ON THE HOT SIDE
PIGGYBACK
ON/OFF SWITCH
Note: To operate the appliance without a wall control
or remote control, connect the ON/OFF switch located
inside the control cavity of the appliance.
NOTE: 1. Ignition module, valve, pilot, and wall switch operate on 3 volts.
Uninterrupted 120 VAC is required at junction box unless equipped with battery back-up.
Figure 6.4 Intellifi re Pilot Ignition (IPI) Wiring Diagram
18
Outdoor Lifestyles by Hearth & Home Technologies • Twilight-II-C Installation Manual • 2368-970 Rev. C • 2/15
PLUG-IN
3V TRANSFORMER
ON/OFF
WALL
SWITCH
FLAME SPARKER/
SENSOR
IGNITION
MODULE
(3V)
LOW VOLTAGE
VALVE
SEE NOTE 1
GROUND
REMOTE
CONTROL
NEUTRAL
WHITE WIRE
CAN BE
PLUGGED
INTO ANY
OF #1-#5
LOCATIONS
ON THE
NEUTRAL SIDE
TRANSFORMER
3 VAC
PLUG IN
BRN
JUMPER WIRE
BRN
IGNITION MODULE
3 VAC
HOT
BRN
WIRE
ASSEMBLY
INTERMITTENT
I
PILOT
IGNITOR
S
WHT
ORG
GROUND TO
FIREPLACE
CHASSIS
BRN
VALVE