Displaying The Amount Of Media Remaining - Roland VersaArt RE-640 User Manual

Description
When "STOP" is selected, printing pauses and so colors may be uneven. Ensure a sufficient amount of remain-
ing ink before you begin printing.
When "CONT" is selected, printing does not stop even if ink runs out completely. To replace the cartridge, wait
until printing ends or press
Default Setting
[EMPTY MODE]: STOP

Displaying the Amount of Media Remaining

You can display how much of the media in use is left. First, you set the amount of media remaining, the amount
remaining is displayed at the top menu until it reaches zero.
Procedure

Press .

MENU
SHEET REMAIN

SHEET REMAIN
SET LENGTH

SET LENGTH
0.0 m 25.0 m

This display is updated.
SETUP SHEET
L 25.0 m
Description
If you cancel the setup such as by removing the media or raising the loading lever, the amount remaining at
that time flashes on the screen.
Because the amount of media remaining is not updated automatically when you change the media, redo
the setting whenever you change the media. You can also make the setting display this menu automatically
whenever you change the media. See the next section, "Making Sure to Verify the Setting for the Amount
Remaining Every Time the Media Is Changed"
Note: The remaining amount that is displayed is only an estimate, and its accuracy is not assured.
to pause printing.
Press to display the left figure.
Press , and then
Press .
Press
remaining.
Press to enable the setting.
Press to go back to the original screen.
If setup has not been
performed, the set value
flashes.
Output Operation Management
.
to set the current amount of media
5
107