Table of Contents
Advertisement
Note: Make sure the sensor is mounted vertically and not lying down on a flat surface. This will
insure optimum reception.
3.2 Wireless Reception Considerations
Wireless signals are impacted by distance, interference (other weather stations, wireless phones,
wireless routers, TVs and computer monitors), and transmission barriers, such as walls. In general,
wireless signals will not penetrate solid metal and earth (down a hill, for example).
The following is a table of reception loss vs. the transmission medium. Each "wall" or obstruction
decreases the transmission range by the factor shown below.
Medium
Glass (untreated)
Plastics
Wood
Brick
Concrete
Metal
5 Console Operation
Note: The console has four keys for easy operation: SET key, ALARM key, MIN/MAX key and
+ key. There are four program modes: Quick Display Mode, Set Mode, Alarm Mode and Min/Max
Mode.
Any program mode can be exited at any time by either pressing the SNOOZE/LIGHT key (on the top
of the display console), or waiting for the 10-second time-out to take effect.
4.1 Quick Display Mode
4.1.1 Quick Display Mode Quick Reference Guide
Command
[SET]
Enter Quick Set Mode, Outdoor
Temperature vs Dew Point
[SET]
Relative Pressure vs Absolute
Pressure
4.1.2 Quick Display Mode Operation
While in Normal Mode, press the SET key to enter the Quick Display Mode as follows (once for
outdoor temperature and dew point and twice for absolute pressure and relative pressure):
1.
Display Outdoor Temperature and Dew Point. Press the MIN/MAX or + key to toggle
between outdoor temperature and dew point.
2.
Absolute Pressure and Relative Pressure. Press the MIN/MAX or + key to toggle between
Version 2.1
©Copyright 2015, Ambient LLC. All Rights Reserved.
Figure 4
Mode
Press
temperature and dew point.
Press [+] to toggle between relative pressure and
absolute pressure.
RF Signal Strength Reduction
5-15%
10-15%
10-40%
10-40%
40-80%
90-100%
Settings
[+]
to
toggle
between
Page 8
outdoor
Advertisement
Table of Contents
