Function Settings - Kenwood KDC-U5049DAB Instruction Manual

Function settings

Press SRC to select a source other than "STANDBY".
1
2 Press the volume knob to enter [FUNCTION] mode.
Turn the volume knob to select [AUDIO CONTROL] or [SETTINGS], then press to enter.
3
4 Turn the volume knob to make a selection, then press to confirm.
■
See table below for selection.
■
Repeat step 3 until the desired item is selected/activated.
■
Press to return to the previous item.
Hold to finish the procedure.
5
[AUDIO CONTROL] : While listening to any source except in STANDBY state or Bluetooth mode.
Item
SUB-W LEVEL –15 — 0 * — +15: Adjusts the subwoofer output level.
BASS BOOST LV1 */ LV2: Selects your preferred bass boost level. ; OFF: Cancels.
SYSTEM Q NATURAL */ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ GAME: Selects a preset sound mode suitable to the
music genre. (Selects [USER] to use the customized bass, middle, and treble settings.)
BASS ADJUST
BASS CTR FRQ 60/ 80/ 100 */ 200: Selects the center frequency.
BASS LEVEL –8 — 0 * — +8: Adjusts the level.
BASS Q FACTOR 1.00 */ 1.25/ 1.50/ 2.00: Adjusts the quality factor.
BASS EXTEND ON: Turns on the extended bass. ; OFF *: Cancels.
MID ADJUST
MID CTR FRQ 0.5K/1.0K */ 1.5K/ 2.5K: Selects the center frequency.
MID LEVEL –8 — 0 * — +8: Adjusts the level.
MID Q FACTOR 0.75/ 1.00 */ 1.25: Adjusts the quality factor.
TRE ADJUST
TRE CTR FRQ 10.0K/ 12.5K */ 15.0K/ 17.5K: Selects the center frequency.
TRE LEVEL –8 — 0 * — +8: Adjusts the level.
BALANCE L15 — 0 * — R15: Adjusts the left and right speaker output balance.
FADER R15 — 0 * — F15: Adjusts the rear and front speaker output balance.
SUBWOOFER SET ON *: Turns on the subwoofer output. ; OFF: Cancels.
DETAILED SET
LPF THROUGH *: All signals are sent to the subwoofer. ; 85/120/160 (HZ): Frequencies higher than the specified
SUBWOOFER value are cut off.
SUB-W PHASE REVERSE (180°)/ NORMAL (0°) *: Selects the phase angle of the subwoofer output to be in line with the
speaker output for optimum performance. (Selectable only if a setting other than [THROUGH] is selected for
[LPF SUBWOOFER].)
SUPREME SET ON *: Creates realistic sound by interpolating the high-frequency components that are lost in AAC/ MP3/
WMA audio compression. ; OFF: Cancels. (Selectable only when playback an AAC/ MP3/ WMA disc or a USB
device, except iPod.)
30
English
Selectable setting (Preset: *)