Ricoh 7650 Operating Instructions Manual page 22

Connecting the Machine
❖ When using in adhoc mode / 802.11 adhoc mode
1
1.
If the IEEE 802.11b interface unit
is working, it is lit in orange.
2.
If it is connected properly to the
network, the LED is green when in
adhoc mode or 802.11 adhoc mode. If
the LED is blinking, the machine is
searching for devices. The LED will
light after a few seconds.
Print the configuration page to verify settings.
Note
❒ For more information about printing a configuration page, see "Printing the
configuration page".
Reference
p.184 "Printing the configuration page"
Checking the Signal
This section describes how to check the machine's radio wave status.
When using in infrastructure mode, you can check the machine's radio wave sta-
tus using the control panel.
A Press [System Settings].
B Press [Interface Settings].
C Press [IEEE 802.11b].
D Press [Wireless LAN Signal].
The machine's radio wave status appears.
E After checking radio wave status, press [Exit].
Press the {User Tools/Counter} key to return to the User Tools / Counter / En-
F
quiry menu.
Note
❒ To check the radio wave status, press [IEEE 802.11b] under [LAN Type] on the
[Network] screen.
12
1
2
ZGDH600J