Table of Contents
Advertisement
STK-106W
Subwoofer Rear Panel:
1. CHANNEL 2 BASS CONTROL – This knob is used to adjust the amount bass applied to the
output signal of Channel 2. Turning the knob in a counter-clockwise direction will decrease
the amount of bass applied to a channel signal, turning the knob in a clockwise direction will
increase the amount of bass applied to a channel signal.
2. CHANNEL 2 TREBLE CONTROL – This knob is used to adjust the amount treble applied
to the output signal of Channel 2. Turning the knob in a counter-clockwise direction will de-
crease the amount of treble applied to a channel signal, turning the knob in a clockwise direc-
tion will increase the amount of treble applied to a channel signal.
3. REVERB – When the REVERB effect is activated it simulates the sound you would get as if you
were playing music in big empty hall. All the reflections you would get with the music bounc-
ing off the walls is digitally simulated in this effect.
4. STEREO LINK - This button is used to wirelessly connect to another STK-106W speaker. This
feature only allows 2 STK-106Ws to be connected wirelessly, the Lead speaker and one
connected speaker.
5. PAIR - Pressing this button will activate the Wireless receiver. See next page 13 for Wireless
Connectivity.
6. MASTER OUTPUT VOLUME - This knob is used to regulate the output volume. Turning the
knob in a clockwise direction will increase the volume level. The Lead speaker in a connected
set up will contol master output volume to all connected speakers. All connected speakers
should be set to a preset volume output.
7. POWER LED - This LED will be lit when you switch on the power.
8. CLIP INDICATOR - If this LED is lit it means that your signal is clipping. To stop the signal
from clipping lower the volume to the point where the LED is blinking along with the bass
beat.
9. MONITOR OUTPUT VOLUME - This knob is used to regulate the output volume to whatever
is currently connected to MONITOR RCA outputs. Turning the knob in a clockwise direction
will increase the volume level.
10. RCA MASTER OUTPUTS - The RCA jacks send a low current unbalanced output signal.
These jacks should only be used for shorter cable runs to signal processors or looping to
a mixer.
11. WIRELESS/MP3 VOLUME – This knob is used to regulate the output signal of any Wireless
signal the speaker is receiving. This knob will also regulate the volume of any source that is
connected to the Auxiliary Input.
12. AUXILIARY INPUT - 3.5mm input jack for use with personal music players.
13. BALANCED RCA LINE LEVEL INPUT – This connection is designed to accept a balanced
line input signal from a mixer or other line level device with a balanced output jack. Use
a balanced cable when the signal cable length exceeds 15 feet, this will reduce excessive
signal loss. Be sure to connect only line level input devices such as mixers and tape
machines to this jack.
©
American Audio
- www.americanaudio.us - STK-106W - Instruction Manual Page 7
®
Controls and Features
Advertisement
Table of Contents
