Garmin GPS 400 Pilot's Manual And Reference page 148

MESSAGES,
8
aBBREVIATIONS
& nav tERMS
are not identical. If necessary, update the database(s) so they match.
Operating software changes may require factory service. Contact
your GARMIN dealer for assistance.
Data transfer error, please re-transmit
during unit-to-unit crossfill of user data (user waypoints and/or flight
plans). The data transfer should be re-attempted.
Data transfer is complete
—The unit-to-unit crossfill of user data
(user waypoints and/or flight plans) has finished.
Database changed, validate user modified procedures
have modified one or more approaches, departures or arrivals from
their original published form. When the NavData® card is replaced
(database update), you must manually verify your changes in the new
database. This message will occur each time a flight plan containing
a modified procedure (generated from a prior database version) is
activated. To eliminate the message, re-create the flight plan from
the new database, then make the desired modifications.
Degraded accuracy
—GPS position accuracy has been degraded
and RAIM is not available. Poor satellite geometry (or coverage) has
resulted in a horizontal DOP greater than 4.0. Additional cross-
checking using another navigation source is required to verify the
integrity of the GPS position.
Display backlight failure
the display backlighting. The unit should be taken to your GARMIN
dealer for service.
Do not use for navigation
must not be used for actual navigation.
FPL has been truncated
because not enough room existed to insert an approach, departure or
arrival. This may occur upon power up when a database change
increases the number of waypoints within an instrument procedure.
—An error was detected
FPL is full - remove unnecessary waypoints
been made to add more than 31 waypoints to a flight plan (FPL).
The GPS 400 will not allow more than 31 waypoints per flight plan.
FPL leg will not be smoothed
leg is too short for smooth waypoint transitions. Expect a rapid
—You
change in the CDI.
FPL waypoint is locked
is locked because the waypoint has been removed from the current
NavData® card (database change), the data card is missing, or the
data card has failed.
FPL waypoint moved
plan (FPL) waypoints moved at least 0.33 arc minutes in the current
NavData® card (database change).
—The GPS 400 has detected a failure in
—The GPS 400 is in Demo Mode and
—The flight plan (FPL) was truncated
—An attempt has
—The upcoming flight plan (FPL)
—At least one flight plan (FPL) waypoint
—The position data for one or more flight