Table of Contents
Advertisement
Fitting the Camera, Equipment and Accessories
Notes
• Do not use lens ID:F. If the lens ID number is set to
F, change it to another ID number. For details on
verifying or changing the ID number of the lens, refer
to the instruction manual of the lens.
• If you use a serial communication lens, more lens
data can be captured by the camera by switching the
lens mode switch to SERIAL. Normal lens operation
is also possible with the switch set to NORMAL.
5
Remove the lens cap.
Attaching the Camera
The explanations in this manual use the BVP-E30/
E30P/E30WS/E30WSP as an example. The positions
of the VF connector and lens connector on the certain
cameras differ from those on the BVP-E30/E30P/
E30WS/E30WSP.
Preparing the camera
1
If the BKP-9057 viewfinder saddle is attached to
the CA-905K/905F, turn the saddle lock knob
counterclockwise to loosen it, then tilt the saddle
backward.
Saddle lock knob
2
Remove the 1.5-type viewfinder.
Push the viewfinder slide inward.
14
3
Aligning the camera mount
After you have aligned the camera mount once, you
need not align it again if the same camera model is
used.
Release lever
1
2
VF connector
Turn the lens locking lever upward and remove the
lens mount cap.
Slide lever
Slide the slide lever to LOCK.
Insert the V-wedge shoe on the base of the camera
into the V-shaped groove on the camera mount,
and slide the camera forward until it clicks in
place.
Lens locking lever
Lens mount cap
Height-adjusting
knobs
Advertisement
Table of Contents
