Attaching To The Camera - Sony CBK-3620XS Operating Instructions Manual

Attaching to the Camera

Notes
• The camera must be updated to the following
software version or later to use this unit.
MPC-3628/MPC-3626: V2.0 or later
MPC-3610: V6.3 or later
Disconnect the unit and reassemble the camera
to its normal state before updating.
• Turn off the camera and wait 30 minutes or
longer to allow it to cool sufficiently before
attaching/removing the unit.
Perform the operation quickly in a dust-free
location to prevent dust and other matter from
entering the camera and adaptors.
• Take care not to damage the connectors and
parts.
• A data transfer error may occur if there is any
dust or other matter adhering to the adaptor
connectors. If this occurs, clean the connector.
• The CBK-3610XS imager block adaptor and
extension cable cannot be attached to the
CBK-3620XS camera body adaptor.
• A 6K imager block can also be attached to the
CBK-3620XS imager block adaptor.
1
Remove the four hex screws on the
bottom and remove the bottom
plate (), then remove the four
hex screws on the front and
remove the imager block from the
camera body ().
22
Attaching to the Camera
Short
Note
Orient the lens side face down when placing
the removed imager block on a flat surface.
If the heat sink side is placed face down, the
flange back distance (flange focal distance)
may change.
2
Attach the imager block, removed
in step 1, to the imager block
adaptor.
Align and attach using the four
supplied hex screws, and tighten using
a hex wrench (tightening torque of 1.4
N·m).
Imager block
Bottom plate