Table of Contents
Advertisement
Use supervisor
code
44
10.5. Description of the menu items
You find a description of the menu items in the following
part. A description on the handling of the menu is in Chapter
7. Setting-up.
Second clear (SEcond clear)
You can set the seconds to zero to set the exact time or
you can set the hours and the minutes by increasing or
decreasing selected digits.
Time set (Time Set)
you can set the hours and the minutes by increasing or
decreasing slected digits.
Changing the User Code (User Code)
The new User Code must be typed in twice, in order to
avoid any typing errors. The mnemonic
warns you to type the code for the second time, after you
have typed it once. If the two codes are not identical with
each other, the mnemonic
the display, and the instrument exits the menu item.
Make sure not to forget the User Code, otherwise a new
one can be defined only if you enter the menu by a
Supervisor Code [Default factory setting: 0000]
Synchronisation mode (Synchron Mode)
Remote synchronisation mode set.
Modes:
= non active
= rounding the seconds down or up
the seconds are set to zero automatically).
= synchronisationton to a preset time written in
menu item (here you can set hours and minutes,
(Bad Code) appears on
DT9102 I4
(Re-Type)
20220103-V0
Advertisement
Table of Contents
