Table of Contents
Advertisement
Use supervisor
code
50
10.5. Description of the menu items
You find a description of the menu items in the following
part. A description on the handling of the menu is in
Chapter 7. Setting up.
The setting of the time (Sec null)
You can set the seconds to zero to set the exact time or
you can set the hours and the minutes by increasing or
decreasing selected digits.
Time set (Time)
You can set the hours and the minutes by increasing or
decreasing selected digits.
Changing the User Code (User Code)
The new User Code must be typed in twice in order to
avoid any typing errors. The mnemonic
warns you to type the code for the second time, after you
have typed it once. If the two codes are not identical with
each other, the mnemonic
the display and the instrument exits the menu item.
Make sure that you do not forget the User Code, otherwise
a new one can be defined only if you enter the menu by a
Supervisor Code [Default factory setting: 0000]
Synchronisation mode (Synchron Mode)
The setting of the remote synchronisation mode.
Modes:
= non active
= rounding the seconds down or up
= synchronisation to a preset time written in the
menu item (here you can set hours and minutes,
the seconds are set to zero automatically).
(Bad Code) appears on
DT9100 B
(Re-Type)
20180905-V120180905
Advertisement
Table of Contents
