Table of Contents
Advertisement
Function
Sequence of operations 1. Enter the menu by the user or the supervisor code.
Exit from the menu item 1. After finishing the settings, press the MENU button to exit
Exit from the menu
26
7.4. Fast time set (02. menu item)
Set the time without setting the seconds to zero.
The way the code should be type in can be found in
Chapter 7.1. Typing the code (password) in. You see on
the display:
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
3. Enter the menu item by pressing the ENTER button.
4. You see the
blinking.
5. Pressing the ▲ button you can increase the value of the
blinking digit:
,
,
,
,
•
Pressing the ► button you can select the next digit, so
you can set all the four digits. (after digit 4 comes digit 1).
from the given menu item, and you see this:
(2. If you want to change the setting you have done just
now, or if you just want to check what you have typed in, go
on with the operation from point 2 of the Sequence of
operations.)
(3. If you don't want to exit the menu (you want to do further
settings), then you may select the desired menu items by
pressing the ▲ button.)
1. Press the MENU button. First the mnemonic
(Save), then the mnemonic
display. With this the storing of the settings is completed.
The instrument has exited the menu and goes on with the
measurement.
.
.
on the display, and first digit is
,
,
,
,
,
DT9102 I4
, etc.
.
(Exit) are shown on the
20220103-V0
Advertisement
Table of Contents
