Table of Contents
Advertisement
DT9100 I4
Function
Sequence of operations 1. Enter the menu by the user or the supervisor code.
Exit from the menu item 1. After finishing the settings, press the MENU button to
Exit from the menu
20180905-V1
7.4. Time-set (02. menu item)
Setting the time (hour : minute) without second clearing.
The way the code should be typed in can be found in
Chapter 7.1. Type in the code (password). You will see on
the display:
2. Keep stepping by pressing the ▲ button until the menu
item
appears.
3. Enter the menu item by pressing the ENTER button.
4. You will see the
be blinking.
5. Pressing the ▲ button you can increase the value of the
blinking digit:
,
,
,
,
•
By pressing the ► button you can select the next digit, so
you can set all the four digits. (after the 4th digit the 1st
digit will appear).
exit the given menu item, and then you will see this:
.
(2. If you want to change the setting you have just done, or
if you just want to check what you have typed in, go on with
the operation from point 2 of the Sequence of
operations.)
(3. If you don't want to exit the menu (you want to make
further settings), then you may select the desired menu
items by pressing the ▲ button.)
1. Press the MENU button. First the mnemonic
(Save), then the mnemonic
the display. With that, the storing of the settings is
completed. The instrument has exited the menu and goes
on with the measurement.
.
on the display, and first digit will
,
,
,
,
,
, etc.
(Exit) will be shown on
31
Advertisement
Table of Contents
