Full Drain Flush; Dimple Diameter - Hoshizaki IM-30CWNE Service Manual

3. FULL DRAIN FLUSH

In some hard water areas, white ice and scaling can be caused. In such case, install a
filter or softener, and change the flush mode from "partial drain flush" to "full drain flush"
according to the following instructions.
Full drain flush – After a freeze cycle ends, the unit drains all the remaining water in the
tank and refills the tank in the next freeze cycle.
Partial drain flush (default setting) – After a freeze cycle ends, the unit leaves the
remaining water in the tank and adds some water to fill the tank in the next freeze cycle.
1) Remove the screw located on the front of the water tank. Move the tank drain pipe to
the drain position (see Fig. 11). Secure the tank drain pipe with the screw.
[Normal Position]
2) Change the following controller board settings from "partial drain flush" to "full drain
flush", referring to "3. [b] MAINTENANCE MODE" in the IM-N series controller board
service manual (E1CK-811).
Full / partial drain flush selection – Maintenance mode No. 14 (0: full, 1: partial)
Icemaking water supply time – Maintenance mode No. 12
Additional icemaking water supply time – Maintenance mode No. 15

4. DIMPLE DIAMETER

See "2. [i] DIMPLE DIAMETER SETTING" in the IM-N series controller board service
manual (E1CK-811).
Tank Drain Pipe
Screw
Fig. 11
65
[Drain Position]