Battery Charging - VTech Eris Terminal VDP658 Quick Start Manual

2. Place the battery in the compartment. Make sure the supplied battery with the
label THIS SIDE UP faces up, as indicated.
3. Align the cover flat against the battery compartment, then press down until it
clicks into place.
IMPORTANT INFORMATION
• Use only the supplied rechargeable battery or replacement battery
(model BT266342). To order a replacement battery, visit our website at
businessphones.vtech.com or call 1 (888) 370-2006.
• If you do not use the deskset for a long time, disconnect and remove the battery
to prevent possible leakage.

Battery charging

Once you have installed the battery, the screen indicates the battery status (see
the table below). The backup battery is fully charged after 16 hours of continuous
charging.
The following table summarizes the battery charge indicators and actions to take.
Battery indicators
The screen shows Low
battery and flashes.
Full battery icon ( )
appears.
Battery Status
Battery has enough
charge to be used for a
short time.
Battery is charged.
12
Action
Charge without
interruption (at least 30
minutes).
To keep the battery
charged, place it in the
charger when not in use.