VTech Eris Terminal VDP658 Quick Start Manual page 16

Adding a corded headset
You can use this deskset hands-free when you install any industry-standard 2.5 mm
corded telephone headset (purchased separately).
Plug a 2.5 mm headset into
the HEADSET jack on the side
of the deskset.
Registering the deskset to the base station
The deskset must be registered to the base station in order to make and receive calls.
To register the deskset:
1. Make sure the base station is connected to power.
2. If the deskset is displaying the following registration instructions, go to step 7.
Otherwise, go to step 3.
Press and hold
HANDSET LOCATOR
key at base for
4 seconds
3. Press MENU on the deskset. The Main Menu appears.
4. Press to scroll to User settings and press SELECT.
q
5. Press to scroll to Registration and press SELECT.
q
6. With This Deskset highlighted, press SELECT.
The deskset screen displays instructions.
7. On the base station, press the HANDSET LOCATOR button for at least four
seconds, then release the button. Both LEDs on the base station begin to flash
slowly.
8. Press the # key on the deskset to begin registration.
The screen displays Registering Please wait.
The process takes up to 10 seconds to complete. When registration is complete,
the deskset beeps and displays Deskset Registered.
If the deskset fails to register, it displays Registration failed. Try again.
Wait for a few seconds and repeat the registration procedure.
Then, press the
#key at the
Deskset.
16