Table of Contents
Advertisement
en Cleaning and servicing
18.6 Cleaning the water outlet
hose at the siphon
If the water outlet hose at the siphon
is dirty or the detergent solution is
not being pumped out, you must
clean these.
Switch off the appliance.
1.
Disconnect the appliance's mains
2.
plug from the power supply.
Loosen the hose clamp and care-
3.
fully remove the water outlet hose.
Residual water may leak out.
Clean the water outlet hose and si-
4.
phon connecting piece.
54
Reattach the water outlet hose and
5.
secure the connection point using
the hose clamp.
18.7 Clean the water inlet fil-
ters.
Emptying the water inlet hose
Turn off the tap.
1.
Set the Bomull programme.
2.
Start the programme and leave it
3.
to run for approx. 70 seconds.
Switch off the appliance.
4.
Disconnect the appliance's mains
5.
plug from the power supply.
Cleaning the filter on the tap
Note: Please read the information in
the Safety → Page 4 and Preventing
material damage → Page 10 sections
to ensure that you use the appliance
safely.
Requirement: The water inlet hose is
empty.
Advertisement
Table of Contents
