Table of Contents
Advertisement
Fault
The water is not drain-
ing.
Water is not flowing
in. Detergent is not
being dispensed.
The spin cycle runs
several times.
Cause and troubleshooting
Drain pump is blocked.
→ "Cleaning the drain pump", Page 51
▶
is activated.
Continue the programme by selecting Centrif. or
▶
Urpumpning and pressing
The water outlet hose is connected too high.
Install the water outlet hose at a maximum height of
▶
1 metre.
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into the compartment for manual dosing (not
for outdoor clothing, sportswear or items stuffed
with down).
If intelligent dosing is activated, reduce the basic
▶
dosage → Page 43.
If you dose manually, reduce the amount of deter-
▶
gent for the next washing cycle with the same load.
Unapproved extension installed on the water drain
hose.
Remove any unapproved extensions from the water
▶
hose. Connecting the appliance
You have not pressed
Press
.
▶
The filters in the water inflow are blocked.
Clean the filters in the water inflow → Page 54.
▶
The tap is turned off.
Turn on the tap.
▶
The water inlet hose is kinked or jammed.
Ensure that the water inlet hose is not kinked or
▶
jammed.
The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
Not a fault – no action required.
▶
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
Troubleshooting en
.
.
61
Advertisement
Table of Contents
