Table of Contents
Advertisement
en Home Connect
If the display shows Home Con-
8.
nect Error, the appliance is not
connected to the home network.
Check whether your appliance is
‒
in range of your home network.
Reconnect the appliance to the
‒
WLAN home network (Wi-Fi)
with WPS function.
Connect your appliance to the
9.
Home Connect app → Page 46.
16.4 Connecting your appli-
ance to the Home Con-
nect app
Requirements
¡ The appliance is connected to the
WLAN home network (Wi-Fi).
¡ The Home Connect app is open
and you have logged on.
Set the programme to position 3.
1.
a The display shows APP.
Press
.
2.
a The appliance connects to the
Home Connect app.
Once your appliance is displayed
3.
in the Home Connect app, carry
out the last steps in the
Home Connect app.
a If the display shows con, the appli-
ance is connected to the
Home Connect app.
16.5 Activating Wi-Fi on the
appliance
Note: When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
Press and hold
1.
seconds.
Set the programme to position 4.
2.
a The display shows Con.
46
for approx. 3
Press
repeatedly until the dis-
3.
play shows on.
a Wi-Fi is activated.
16.6 Deactivating Wi-Fi on the
appliance
Press and hold
1.
three seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press
repeatedly until the dis-
3.
play shows oFF.
a Wi-Fi is deactivated.
Note: If Wi-Fi is switched off and your
appliance was previously connected
to your home network, this connec-
tion will be re-established automatic-
ally when Wi-Fi is switched back on.
16.7 Software update
Requirement: The display shows .
Press and hold
1.
seconds.
Set the programme to position 6.
2.
a UPd appears on the display.
Press
.
3.
a The software update is installed.
a If End is shown on the display, the
software update is installed.
Note: The software update may take
several minutes. Do not switch off the
appliance while the software update
is in progress.
16.8 Resetting the appliance
network settings
Press and hold
1.
3 seconds.
Set the programme to position 5.
2.
a The display shows rES.
for at least
for approx. 3
for at least
Advertisement
Table of Contents
