Table of Contents
Advertisement
Insert the pump cap and screw it
4.
on.
90°
The handle on the pump cap must
be in a vertical position.
Insert the maintenance flap and
5.
lock it into place.
1
Close the maintenance flap.
6.
Before the next wash
To prevent unused detergent from
flowing straight into the outlet in the
next wash, run the
after you have emptied the drain
pump.
Turn on the tap.
1.
Insert the mains plug.
2.
Switch on the appliance.
3.
Pour 1 litre of water into compart-
4.
ment II.
Start the
programme.
5.
2
programme
Cleaning and servicing en
Cleaning the water outlet
hose at the siphon
If the water outlet hose at the siphon
is dirty or the detergent solution is
not being pumped out, you must
clean these.
Switch off the appliance.
1.
Disconnect the appliance's mains
2.
plug from the power supply.
Loosen the hose clamp and care-
3.
fully remove the water outlet hose.
Residual water may leak out.
Clean the water outlet hose and si-
4.
phon connecting piece.
45
Advertisement
Table of Contents
