Epson Perfection 636U User Manual page 21

7. After the scanner software installation is complete, the EPSON Screen
Calibration utility automatically starts. You must calibrate your screen and
scanner to reproduce images closely matching the originals.
In the following window, move the slider to the right or left until the shades of the
horizontal gray stripes appear similar. View the screen from a short distance. The
gray stripes will not perfectly blend together; however, try to make the two tones
match as closely as possible.
8. Click
OK
9. Click
Finish
Hardware Wizard.
16
You don't need to change the screen calibration again so long
as you continue to use the same monitor. If you need to
recalibrate your screen at a later time, click Scanners and
Cameras in the Control Panel. On the Devices tab, select
Scanner. Click Properties, then click the Calibration button.
before calibration
to register the calibration setting.
to exit the Add New
after calibration