Scanning Film - Epson Perfection 4180 Start Here Manual

EPSON Scan
Color Restoration is available in Home and Professional Modes.
1
To select Color Restoration, start EPSON Scan. You see a screen similar to
this (in Home Mode):
2
Click the Preview button at the bottom of the screen to see your image.
3
Click Image Adjustments.
4
When the Image Adjustments screen appears, select Color Restoration.
Then click Close.
5
Click the Scan button on the screen to scan your image.

Scanning Film

The scanner cover has a built-in film adapter. To scan film
or negative strips, slides, or transparencies, you need
to remove the document mat from the scanner cover and
insert the film in a holder.
The scanner comes with 3 different film holders: one for
35 mm film or negative strips, one for 35 mm slides, and
one for medium-format (120/220) transparencies.
1
Make sure the film adapter cable is connected
to the scanner (see step 3 in "Connect the
Scanner"). If you need to connect
the cable, first turn the scanner
off. Then turn it back on again
after you connect the cable.
2
Lift the scanner cover all the way up
and slide the reflective document mat
up and off of the scanner cover.
3
Follow the instructions for the type of film you are scanning:
If you are scanning 35 mm film or negative strips or medium-format
(120/220) transparencies, slide the film into the corresponding holder,
with the film's shiny side facing down.
35 mm film or negative strips
Place the film holder on the scanner as shown. Make sure the small circle
on the tab fits into the hole on the scanner.
Make sure this
calibration space
is uncovered
Medium-format transparencies: Slide the film
into the holder as shown. Then lower the
cover and press the tab to lock it in place.
Cover tab