Request To Exit; Locking Device; Led's - Progeny P2 System Hardware Manual

Request to Exit

A normally open connection, or "push to make" connection, Request to Exit button may also be fitted to the P2
Reader. This will be piggy backed to the controller over reader interface. The P2 reader must be fitted to Reader
A on the P2 Controller and the RQE feature enabled in Doors Express for this configuration to work

Locking Device

A low power locking device can also be fitted to the reader with a rating of no more than 100mA by wiring in to
the positive and negative Lock terminal of the P2 Reader.

Led's

There are two bi-colour Led's on the reader. The lower LED flashes red until a credential is present when it will
stay red and hold until the proximity credential is removed. The upper LED will turn green when a valid card is
presented to the reader and red when the card is invalid.
Figure 13
19