Table of Contents
Advertisement
Mounting
Please note that the read range of the P2 Reader will be reduced when fitting the optional stainless steel plate for
outdoor or vandal resistant protection.
Connections
The P2 Reader should be connected to the P2 Controller using a four core cable. The cable run should be no
more than 100 metres. Data is transferred between the P2 Reader and P2 Controller through the respective X
and Y terminals and should be linked X to X and Y to Y.
Door Sensor
A normally closed (contact closed when the door is closed), door contact sensor can be fitted to DR on the
reader. This will be piggy backed to the controller over reader interface. The P2 reader must be fitted to Reader A
on the P2 Controller and the Door sense feature diverted in Doors Express for this configuration to work.
Figure 11
Figure 12
18
Advertisement
Table of Contents
