Progeny P3.GPRS V4 Manual

(Addendum to P3.net Manual)
SAFETY NOTES

Please read this manual carefully before attempting to install, program or operate the Progeny access control
equipment.

This equipment must be installed in line with all relevant regulations and standards.

Make sure that wiring is rated according to fuses and current limits of relevant power supplies.

Apart from the mains supply, all connections to this unit must be SELV level. (Safety Extra Low Voltage, BS EN
60950 1992)

No users should access inside the control box. Access is limited to qualified personnel only. All user programming
for the controller is either done at one of the keyboards or at the PC.

Every effort is made to ensure that this manual is complete and free from errors. However we reserve the right to
make changes to these products and this manual without notice.

No liability is accepted for loss damage or injury as a consequence of using these products or instructions.
Firmware Version Number:
WEEE Certificate Number:
 Copyright BSB Electronics Ltd T/A Progeny Access Control
Document Number: MAN0006
P3.GPRS V4 Manual
Document Number: MAN0006
PSU: 3.24 and later
P3: 3.35 and later
GPRS: 4.41 and later
EMC & LV Certificate
Number:
2012, all rights reserved.
Issue: 6
3006 P3.GPRS
17851
WEE/JG2915VS
Page 1 of 6