C-TEC CAST XFP Commissioning & Programming Quick Start Manual page 12

CAST XFP ANALOGUE ADDRESSABLE FIRE ALARM PANEL
4.6.2 Assign an Input Device to a Zone
An input device is any device that can signal an event such as 'fire', 'fault', etc. to the fire alarm panel,
e.g. smoke/heat detectors, MCPs and the input channels of I/O units.
Click on the Loop Summary tab to open the Loop Summary window.
For each input device, click on the drop-down menu in the Zone/Group/Set column to assign a
device to a Zone (see FIG.4).
FIG.4 – Loop Summary Window
Note: In order to make any changes to the Zone/Group/Set data in the Loop Summary window,
click on the Enable Type/Zone Changes box.
Page 12 of 16  Commissioning/Programming Quick Start Guide  Approved Document No. DFU5020010 Rev 4