Icom IC-V3MR Instruction Manual page 30

6
OPTIONS
VOX function
DTurning the VOX function ON or OFF
The VOX function can be turned ON or OFF� The VOX
function automatically switches between receive and
transmit during voice operation�
1� Connect the optional HS-94, HS-95 or HS-97 and
VS-4LA, OPC-2004, or OPC-2004LA� (p� 6-3)
2� Rotate [VOL] to turn OFF the transceiver�
3� Set [Rotary Selector] to any channel other than
Channel 16�
4� While holding down [Upper], rotate [VOL] to turn
ON the transceiver and turn the VOX function ON
or OFF�
• A beep sounds when the VOX function is OFF�
• Two beeps sound when the VOX function is ON�
5� Rotate [VOL] to turn OFF the transceiver, then
turn it ON again to restart the normal operation�
NOTE: When using the VOX function, we
recommend setting the microphone gain to 3�
However, you can adjust it to suit your operating
environment (including your headset performance)�
(p� 3-5)
DSetting the VOX gain
The higher value makes the VOX function more
sensitive to your voice�
1� Connect the optional HS-94, HS-95 or HS-97 and
VS-4LA, OPC-2004, or OPC-2004LA� (p� 6-3)
2� Rotate [VOL] to turn OFF the transceiver�
3� Set [Rotary Selector] to Channel 16�
4� While holding down [PTT] and [Upper], rotate
[VOL] to turn the transceiver ON and enter the
VOX gain adjustment mode�
5� Push [Upper] to increase, or push [Lower] to
decrease the VOX gain while speaking into the
optional headset at your normal voice level�
L The adjustable range is between 1 (low sensitivity) to
10 (high sensitivity)�
• A beep sounds after pushing [Upper] or [Lower]�
An error beep sounds when the adjustable range is
exceeded�
6� Rotate [VOL] to turn OFF the transceiver, then
turn it ON again to restart the normal operation�
NOTE: Set the microphone gain before setting the
VOX gain� (p� 3-5)
6-4