Icom IC-V3MR Instruction Manual page 12

2
PANEL DESCRIPTION
Assignable Software Key functions
Disable
Set to disable the key�
NOTE: This key function is assignable to only
[Ext� Emer]�
Null
No function�
Scan Start/Stop
Push to start or cancel a scan�
When the Power ON scan function is turned ON, push
to pause the scan� The paused scan resumes after
the Auto Reset timer period ends�
Prio A, Prio B
Push to select the Priority A or Priority B channel�
Prio A (Rewrite), Prio B (Rewrite)
z Push to select the Priority A or Priority B channel�
z Hold down for 1 second to assign the operating
channel to Priority A or Priority B channel,
respectively�
Moni*2
z Push to turn the CTCSS (DTCS) or 2-tone squelch
mute ON or OFF�
While pushing this key, the transceiver opens any
squelch, or deactivates any mute�
z Depending on the presetting, hold down for 1
second to cancel the scan�
CAUTION: Since FCC Part 95�2725 requires
monitoring the channel before transmit, Lockout
(Busy lockout) must be enabled if Moni (Monitor)
button was disabled�
Lock
Hold down for 1 second to turn the Key Lock function
ON or OFF�
L Even when the lock function is activated, [Moni*2],
[Call] (Including [Call A] and [Call B]), [Emergency],
[Surveillance] and [Lone Worker] are not locked�
Lone Worker
z Push to turn OFF the Lone Worker function�
z Hold down for 1 second to turn ON the Lone
Worker function�
L If no operation occurs during the specified period, the
Emergency function is automatically turned ON�
NOTE: To use the Lone Worker function, set the
related settings using the programming software�
High/Low
Push to select the transmit output power level
temporarily, or permanently, depending on the
presetting�
DTMF Autodial
Push to transmit a DTMF code�
Call, Call A (Code 1), Call B (Code 2)
Push to transmit a 2-Tone code�
Emergency
z Hold down during the Emer SW ON timer period to
turn ON the Emergency function�
z Hold down during the Emer SW OFF timer period to
cancel the Emergency function, before transmitting
an Emergency call�
NOTE: Set the related settings using the
programming software�
Surveillance
z Push to turn OFF the Surveillance function�
z Hold down for 1 second to turn ON the Surveillance
function�
When this function is turned ON, the beep is not
heard and the status indicator does not light, even
when a signal is received, or a key is pushed�
Siren
Hold down for 1 second to emit a siren sound�
This function can be used for situations other than
an emergency alert, such as a security alarm, for
example�
L The transceiver emits the siren sound until the transceiver
is turned OFF�
Sp. Func 1, Sp. Func 2
Sp� Func 1 and Sp� Func 2 are reserved�
2-4