0
I C O M CS-207
the original disk. Operate the program using the
This cloning program is designed to perform data
setting and cloning for the dual band transceiver
IC-207H.
cloning operations are performed from
computer's keyboard including power ON -
only connect to a DC power supply is needed
IC-207H
n
Installation and initial setup'
Connect the transceiver and
DC power supply to the the transceiver.
nect a
To
install
the
CS-207
disk is in drive A, type as follows at the DOS prompt:
A: C:\ICOM\CS207 [Enter]
A:\INSTALL
Program drive '7" Target drive/directory
A target directory is created if it does not already
exist; CS-207 cannot be installed to the root directory.
After the installation is finished, the CS-207 initial
setup screen appears and the transceiver model is
checked. Proceed as follows:
port with the [ t]/[ $1 and [Enter] keys.
launched. Set or modify the data as desired.
See the back page for operation.
l
the program.
GETTING STARTED
safe p/ace.
a
CONNECTIONS
-646 Cloning cable
be purchased separately)
INSTALLATION AND PROGRAM START UP
PC as above
then con-
cloning
software
to
OPERATING GUIDE (for IC-207H)
To use this program, the following hardware and
software are required:
IBM PC/AT or PS/2 compatible computer with an
l
RS-232C serial port
MS-DOS, PC-DOS or IBM DOS ver. 5.02 or higher
l
. OPC-646 CLONING CABLE
n
Starting the program
To start the program after installation, operate as
follows at the DOS prompt:
l
(at the installed directory)
n
Operating from a floppy disk
This program can be operated from a floppy disk.
remove
program
NEVER
the
drive while the
program is running.
NEVER set the floppy disk as write-protected.
Cloning will take 20 sec. or more when operating from a
Portions of this software are copyrighted by Microsoft Corporation.
MS-DOS is a Microsoft trademark.
, . - . . - - -
I
Personal
computer
disk from the floppy disk