Hange Of Static Pressure - Hisense DC Inverter Unitary Series Use And Installation Instructions

6.2 Change of Static Pressure
The static pressure outside the indoor unit can be chosen .
6.2.1 For AC MOTOR type:
You can change the static pressure by changing the fan motor terminal which refer to following Fig6.2.1.
Low static pressure
High static pressure
Note:
*:Default Settings is
The noise under high static pressure is higher than static pressure .
6.2.2 For DC MOTOR type :
The static pressure can be freely adjusted by using specific wire remote controller.
LCD
Fig 6.2.2
Static pressure setting:
Hold down both"MODE"button and"ADD.FUNC."button for 3 seconds, symbol
1
blinking at the same time.
2 Press" / "button to adjust parameter number until display "17", and press "ENTER"button to entering
system parameter adaption state, symbol
Select desired parameter code 10 by pressing" / "button , and press "ENTER" button to confirm.
3
4 Select desired function code to rewrite the parameter values by pressing " /
"ENTER" button to confirm.
5 Press "ON/OFF"button or "CANCEL"button to quit.
If you still have any trouble, please contact local technical service center of our company for further information.
WHT
RED
Fig 6.2.1
low static pressure
Error Indicator
Parameter Code
Function Code
Installation and Maintenance Installation and Maintenance
Fan motor
Model
18K
by factory.
Model
(Capacity
Btu/h)
9K/12K
24K
30K/36K
42K/48K/60K
stop blinking.
12
High static
Low static
pressure
pressure
10Pa*
The range of
Function code set
static pressure
1-50，more than 50 is 50 Pa,
0-50Pa
[default: 0(0Pa)]
1-50，more than 80 is 80 Pa,
0-80Pa
[default: 0(25Pa)]
1-120，more than 120 is 120 Pa,
0-120Pa
[default: 0(37Pa)]
1-120，more than 120 is 120 Pa,
0-120Pa
[default: 0(50Pa)]
and parameter code
"button , and press
30Pa